tl;dr: all the individual links have a high bandwidth on their own, but the end-to-end connection has a low bandwidth.
I’m stuck on debugging it, what should I measure and what should I try?
Details below.
I have two routers (both are Ubiquiti UDR), and a NAS (Synology). The NAS is connected directly to one of the UDRs. Between the two routers there’s a site-to-site wireguard VPN using Ubiquiti’s “Magic Group” feature.
I measured all the links with iperf3, and on their own they all have a high bandwith (see pic below):
- The link between the two routers over the VPN are fast enough (200 Mb/s+),
- the link between the NAS and its neighbor router is also fast (500 Mb/s+).
However, the end-to-end connection between the NAS and the remote router is extremely low bandwith, 4-10% of what should be possible: 10-23 Mb/s. When I mount the NAS on a client on the remote network, the bandwith is even slower, copying a file is max 6Mb/s, with drops to 0.
I believe I ruled out issues with the VPN: I removed the VPN connection on the routers, forwarded the port used by iperf, and measured the bandwidth between the remote router and the NAS directly via its public IP. This generated about the same result as the measurement over the VPN.
Other potentially useful info:
- There’s a large distance between the two routers. Traceroute measured 12 hops, with a whopping 179ms latency.
- The connection from the NAS is weirdly asymmetric.
- When the remote router downloads from the NAS, the speed settles on a stable 21.0 Mbit/s, with an occasional bump to 31.5 Mbit/s. There’s a ~5% overhead (packet loss?) during the test.
- On the opposite direction, NAS downloading from remote router, the speed starts from 1.71 Mbit/s, gradually increasing until 36.5, then drops to 0, then starts hiking again. The packet loss is under 1%.
- The connection between the NAS and its directly connected router is also inexplicably asymmetric, but it’s stable without any changes in bandwith during the test and no packet loss visible on the iperf test.