Earlier this evening, I was leaving for work when I encountered a completely dead 2014 BMW i3. I know from reading the i3 forum that it HAD to be the 12v battery. I called for roadside assistance and listed my car as a “hybrid“ because I do have the gas-powered range extender. While I waited for the tech to arrive, I disengaged the high voltage battery, as I had read about this multiple times on the i3 forum. When the tech got to my house, I told him that I had made the disconnect, and he said that we needed to reconnect it, or the charge wouldn’t “work.” I was skeptical, but I agreed, and we reconnected the 12v to the HV. Prior to the “jump,” my HV battery was charged to 100%. After he hit the 12v with his battery pack, my HV percentage wouldn’t even show up on the screen. My Rex percentage showed up, but not the HV. Is it possible that the ultra high voltage from his battery pack knocked the charge out of my HV? Could it have done more extensive damage? (Dear God, I hope not!) The car would only stay on for a few seconds, and then shut off again. So, I plugged the car back in to charge the HV, and I ordered a trickle charger to put on the 12v again tomorrow.
I’m just looking for someone to reassure me that there is some sort of safewall that would not allow my HV to be “overcharged“. The 12v doesn’t feed the HV directly, correct? Like, that massive current wouldn’t travel from the 12v through to the HV? This is a 2014, so my highest charging level is two. I should have insisted that we at least try the jump without the batteries connected, but I didn’t want to be contrary.
Please tell me I didn’t kill my perfect car….
Jumpstarting a car isn’t like shocking someone’s chest with a defibrillator. There is no massive current. The mobile ones are just a smaller 12V battery that will provide enough juice for your car to turn on in place of your flat 12V battery. Once the car is on, it takes over the job of charging the flat battery so the jumpstarter battery can be removed. You can’t jumpstart an EV with the HV service disconnect pulled, because your whole goal is to get enough power from the jumpstarter’s battery to pass the car’s startup self-checks that happen before the HV battery is engaged and takes over.