Ok so, I did a test. I’m confused. I need your input to figure out what’s happening. I mix and match 3 DAC/AMPs with 2 IEMs. The question I have is that, if DAC/AMPs are supposed to be transparent, aka outputting a flat FR, what else can affect the tonal balance in the chain?

Gear list:
HIFIMAN EF600(Low Gain NOS), Cayin RU6 NOS, FiiO BTR7
Truthear Hexa, Moondrop Aria 2

I tried my best keeping all the volume same, vocals especially. The EF600 has A LOT more bass than the other two, but also having a much clearer instrument separation and clarity, by a great margin. BTR7 has somewhat good bass while RU6 has the least. RU6 has the least clarity as well.

I know this may sound obvious, “Duh, DAC/AMPs are different.” But I’m wondering the root cause of this, like is it because they output different non-flat FR? Or is it the output impedance that’s affecting the sound? I specifically used two IEMs with different setups, single DD and 1DD+3BA, the results are exactly the same so IDK if it is impedance. I’m curious what’s behind this. I know RU6 has very bad THD so a lack of clarity can be explained. BTR7 has better THD on paper than EF600 but the actual perceived clarity is audibly lacking. It could be IMD or something else but the drastic difference of tonal balance is beyond my understandings.

  • 0patienceB
    link
    fedilink
    English
    arrow-up
    1
    ·
    1 year ago

    The ef600 has 32 ohm output impedance. That’s going to have an effect on the FR of almost every IEM on the market.

    • Quiet-Fee7728OPB
      link
      fedilink
      English
      arrow-up
      1
      ·
      1 year ago

      Can you please provide a link to that? I’ve been searching for its impedance but haven’t found any info.

  • Additional-Basil-893B
    link
    fedilink
    English
    arrow-up
    1
    ·
    1 year ago

    If the EF400 is indicative of hifiman standards, I wouldn’t expect great things from the EF600 measurement wise - https://www.l7audiolab.com/f/hifiman-ef400/

    Honestly none of these measure that well compared to other options out there, if you’re looking to power IEMs then I would look towards one that measures cleanly e.g. moondrop dawn/dawn pro, tanchjim space, tempotec sonata bhd pro. When you have messy measurements I’d imagine tonal balance would be affected as well and not just clarity, but I’m not sure in what way

    • Quiet-Fee7728OPB
      link
      fedilink
      English
      arrow-up
      1
      ·
      1 year ago

      Yea I’m wondering how the EF600 measures but I can’t find anyone doing it. Hifiman has EF500 and EF499 now as well. The EF400 uses a worse r2r chip so I assume other ones should be technically better, especially when correlating to their price. After all, they are r2r so they’ll always measure terrible compared to delta-sigma ones. But measurements aren’t everything. The btr7 was in wired mode and it has much lower THD than ef600 as claimed by manufacturer. But I still think the ef600 sounds more “resolving” and “natural”. It could be placebo tho since it wasn’t a blind test. At that low level of THD I doubt it would be audible anyway so it’s probably something else.

  • OphanilB
    link
    fedilink
    English
    arrow-up
    1
    ·
    1 year ago

    I have the RU6 and RU7, and they both lack clarity and resolution when I drive them with through my laptop with the stock cable. Oddly, they both sound best through my iPhone connected with a DDhifi09s lightning cable, the muddiness clears up and everything is crisp and detailed.

    I’d pick up a DDhifi usb-c to usb-c or usb-c to lightning cable and try it. If you get it from Amazon you can just return it if it doesn’t work, but it was a big difference for me. I’ve also heard of people using USB purifiers to handle the noise.

    • Quiet-Fee7728OPB
      link
      fedilink
      English
      arrow-up
      1
      ·
      1 year ago

      Are you sure it’s not placebo? As far as my understanding goes, it’s technically impossible to have “sound quality” variance on a digital cable. It’s just ones and zeros. If it fails to transmit the signal as it is, it will probably click and pop. Analogue cables could sound different because of their impedance.

      • OphanilB
        link
        fedilink
        English
        arrow-up
        1
        ·
        1 year ago

        Definitely not placebo, the difference is as clear as day. Most cables transmit power and data through the same wires, the DDhifi cables split the usb power and usb data into two separate, shielded paths.

        I love how redditors want everything to a placebo so they don’t have to spend more money. 😂

        • Quiet-Fee7728OPB
          link
          fedilink
          English
          arrow-up
          1
          ·
          1 year ago

          Oh please don’t assume that. I’ve spent a lot of money and I don’t mind. I will try the cable. It never hurts to try something new. At least for me, it’s not saying everything is placebo. It’s because placebo plays a huge part in this hobby, so keeping in mind of its contribution is always a good idea when looking for something more objective.