Exactly what the title says. No this is not a troll post. There was some hardstuck water in my Holas which sunlight couldn’t remove.

While I knew that my Holas have a N52 magnet inside them and that this could go horribly wrong because of the Faraday’s cage, I thought just 2-3 seconds of microwaving wouldn’t do anything. Also had this exact thought running in my mind “bad things don’t happen to me” right before putting them inside. I was in semi-denial.

The driver tore off in a somewhat audible boom and now the right one doesn’t work. The cable is fine because I didn’t put it in the microwave, but the washing machine destroyed the mic last month and now it responds in flat noise.

Luckily they were worth only $20 but I’m still a student so it was somewhat major of a loss. In need of advice if recovery is possible.

TL;DR: Don’t microwave your IEMs.

  • fediverserEnglish
    1·
    11 months ago

    This post is an automated archive from a submission made on /r/headphones, powered by Fediverser software running on alien.top. Responses to this submission will not be seen by the original author until they claim ownership of their alien.top account. Please consider reaching out to them let them know about this post and help them migrate to Lemmy.

    Lemmy users: you are still very much encouraged to participate in the discussion. There are still many other subscribers on !headphones@hi-fi.community that can benefit from your contribution and join in the conversation.

    Reddit users: you can also join the fediverse right away by getting by visiting https://portal.alien.top. If you are looking for a Reddit alternative made for and by an independent community, check out Fediverser.

  • nelisteBEnglish
    1·
    11 months ago

    You don’t need sunlight, just leave that iem alone for few days.
    Make the process faster using silica gel, or just put in warm place like inside PC case.
    Water evaporates.

    For me it depends on what kind of water that got into iem, one time I just double down and clean it again with alcohol.

  • binnedPixelBEnglish
    1·
    11 months ago

    Thanks for sharing as I was going to microwave my Sennheiser HE-1 to lower the humidity in the earcups.

  • Quiet-Fee7728BEnglish
    1·
    11 months ago

    I think you missed something here. Do you know if you put a tiny water drop in the microwave and it’ll never heat up? It’s too small compared to the wavelength so it won’t work. So even if the microwave wouldn’t damage your IEM, this method wouldn’t remove the water either.

    A good solution is to put it in a sealed box with anything moist absorbing substance, like silicone gell or calcium oxide. Because the relative humidity of the surrounding air is going low, the water in the IEM would eventually evaporate.

  • junbi_okBEnglish
    1·
    11 months ago

    The technical term for this kind of damage is permafucked.

  • i2ehanBEnglish
    1·
    11 months ago

    Seriosu question. Do they sound warmer?

  • DeadrosesTMYBEnglish
    1·
    11 months ago

    “bad things don’t happen to me”

    well they do if you’re being stupid

  • delusionalcookieBEnglish
    1·
    11 months ago

    I went and cuddled with my Blessing3s after reading this, just to make sure they knew they’d be ok.