Just finished this install up with with a custom PCB

I’ve been dabbling in PCB design recently, so decided to make a replacement PCB for the commonly used modbo 5 modchip.

This allows you to pass wires through from underneath, instead of wrapping them over the sides (if you decide to install the chip on top of certain points).

With this install, I was able to hide 8 wires total, all under the chip.

This is by no means necessary, more just for fun and curiosity. But I think it makes for a clean install ✌️

  • fediverser
    1·
    1 month ago

    This post is an automated archive from a submission made on /r/cableporn, powered by Fediverser software running on alien.top. Responses to this submission will not be seen by the original author until they claim ownership of their alien.top account. Please consider reaching out to them let them know about this post and help them migrate to Lemmy.

    Lemmy users: you are still very much encouraged to participate in the discussion. There are still many other subscribers on ! that can benefit from your contribution and join in the conversation.

    Reddit users: you can also join the fediverse right away by getting by visiting https://portal.alien.top. If you are looking for a Reddit alternative made for and by an independent community, check out Fediverser.