240,xxxkm, 3.8L sc. When I turn the car on, immediately the display tells me “no abs” “no traction control” “service traction system”. I have replaced all the wheel hub assemblies when I bought the car, and have owned it for a few years, but the first day all the error messages started happening I found the wire on the harness of my rear driver side was broken. I spliced on a new connector I got from Chev but the plastic connections that secure it don’t match the abs hub. Even though it’s the wrong one it still connects together and i still get the error messages. I ohm tested each abs on the hub and it read 1000ohms, and the voltage on the wires is 4.8V all around. What should I check next? I have a scanner that reads ABS and all that and it comes back with nothing.