Hi everyone i am at my witts end. Ive tried chisel/hammer, prybar, and tapping hammer on the end of prybar. After hours of doing that, it pulled out maybe 1mm lol. I used a slide hammer and it ripped the axle off, leaving the cv halfshaft. i went and got an attachment to attach to a vise grip but it keeps slipping off eventually. Ive been at this for almost 3 days now i’m not sure what else i can do at this point. Any advice is appreciated. Thanks!!!

  • vjefhsbOPBEnglish
    1·
    10 months ago

    Thanks everyone for commenting. I ended up getting it out. I went to the store for the 60th time today to get some braided steel. It ended up being to thick to latch behind the halfshaft. I got so mad i took my anger out by going to town with a chisel/hammer again and eventually that worked it out

  • ziksy9BEnglish
    1·
    10 months ago

    I always just use a 16" pry bar and a mallet. The leverage pops em right out.