So, I’ve seen a lot of post about new or existing deck (mostly new) not powering on or charging. The solution that works most of the time is a cmos reset. This resets the bios to stock configuration and can fix decks that wont power on.
Here is how to do it
Make sure the deck is fully off (no lights/fan noise)
Press and hold vol down + three dots button and turn it on
Keep holding the vol down + three dots button for about a minute. The charging LED should start flashing
Wait for a few minutes and, hopefully, the deck will boot right up
Happy gaming!
You must log in or register to comment.
Mine was flashing then the fan was spinning full speed for a seconds and now the led is steady but no sign of life …
I am writing to inform you that I am encountering the same issue with my OLED display. I followed the suggested steps you provided, but unfortunately, the problem persists.
Specifically, the LEDs blink initially, then cease, and subsequently, the fan begins to spin at full speed. However, after this, there is no further response or improvement in the display.
I would greatly appreciate any additional guidance or solutions you could offer to resolve this matter.
How did you exactly perform the reset? How long did you hold the vol down, three dots and power button?
Like you said, 1 minute its fash slowly the the fan spin but noting after that !