At first we thought it was the battery, replaced it after we checked (it was no good even after sitting on a charger), then thinking it could be the alt, so I wanna take the belt off to check. One issue, the tension is insain. I’m not sure what I can do besides either try loosening the alt first then tension or just cut the belt, which doesn’t need to be changed.
Ion know man.
You must log in or register to comment.
Rule 8 - make and model.
It’s difficult to help you much if we don’t know what we’re taking about.
But most likely, you have some sort of tensioner system. Either a spring loaded pulley. Or a manually adjusted pulley. If you don’t know how to undo the belt tension on your vehicle, I don’t think I’d recommend taking the alternator off either. I’d be worried you’d crank down those bolts too hard and snap them.
If you insist on doing this work, Watch some videos specific to your vehicle. Get a service manual. Get a torque wrench, know how to use it, and know where to find torque specs.
Theres a part called the belt tensioner in the serpentine belt system, keeps constant pressure on the belt while in motion,
Look up your make and model online, it will show you where it is and how to correctly remove the belt
Seized component that’s not allowing crankshaft to turn (bc it’s attached to the crank via drive belt) has a unique sound or characteristic when you try to start car. IF that’s what’s happening it’s most often a clutch-style AC compressor locked up. I’ve not known alternators to be able to lock up that hard. Troubleshooting this is seeing if it starts with the serpentine belt removed. Hydraulic belt tensioner, apply constant pressure and they slowly release.